FRV tailoring MTP shooters belt with a D ring.
The shooters belt is actually 2 belts.
The first being an inner trouser belt with Velcro hook on the outside and the second being an outer belt with Velcro loop on its inner face.
So the way it works is you put on your inner trouser belt like you would any normal belt. Then your outer belt (with your pistol, spare mags ect attached) is put on over the inner belt and fastened with the cobra buckle. This creates almost a seamless connection between you and your kit. No more bouncing around of loosely fitted magazine pouches!!
• It is sized to the users waist size. So if your a 32 for example, get the 32.
• The belt is 50mm/2" width.
• 7" of adjustment in the belt.
• It has an inner belt made of 1 layer of webbing with Velcro hook on the outside.
• Black or coyote brown Velcro is used throughout the inner and outer belts.
• A double layer of webbing is used on the outer belt for rigidity.
• Mollie loops run along the top and bottom of the outer belt which fit any mollie or palls attachable pouches or holsters.
• Austrialpin cobra buckle rated to 4000LB's
• The outer has between 18 and 24 Columns size dependant.
The belt comes with a D ring, it's on the left hand side of the belt with the female part of the buckle. The webbing used is Milspec and can withstand loads of 2000LB plus, as can the buckle and ring. Both raw edges of the belt are captured in the male end of the buckle with the D ring being in the middle of the full length of webbing. The two layers of webbing are sewn 5 times down the full length of the belt for strength and rigidity. Just bear in mind that it is not tested as a fall prevention aid and using it in this way is at the users own risk.